Maintenance measures of ball mill

The maintenance of the ball mill is a must for the operator. The formulation of reasonable maintenance measures is the key method to prolong the service life of the ball mill, increase the production capacity and reduce the failure rate, and it is also a direct method.

• Keep the equipment clean

Cleaning work is a must for the ball mill. Only by removing all the impurities inside and outside the machine can the normal operation of the equipment be ensured. If there are too many impurities, not only will it be difficult to start the equipment, but also the phenomenon of grinding and poor output will occur. The key is to cause damage to the equipment to a certain extent. It is recommended to clean the ball mill regularly, such as the base. When there are too many impurities in the base, it is easy to rust. Therefore, the impurities should be removed first, and the base should be cleaned.

• Reasonable lubrication

After the ball mill is used for the first time and continuously operated for one month, the lubricating oil must be replaced once (select the correct lubricating oil). When replacing, all lubricating oil must be removed, and the ball mill should be cleaned, and then replaced with new lubricating oil. In the subsequent use of the ball mill, the lubricating oil must be replaced every six months of operation. When it is found that there is too much oil shortage, the cause should be analyzed in time. At the same time, the lubrication of each lubrication point should be strengthened. It is recommended to add grease to the lubrication point every week during the running-in period, except for special requirements.

• Periodic inspection

Regularly check and repair all parts of the ball mill, so that not only the abnormalities and problems of the machine can be found in time, but also the occurrence of failures can be prevented. At the same time, the ball mill will be maintained. For example, check whether there is oil leakage on the joint surface, whether there is water leakage and whether there is a leakage phenomenon, and determine the use state of the fastener. Especially for some vulnerable parts, the frequency of inspection and timely maintenance and repair should be strengthened to extend the service life of the parts and increase the service life of the ball mill.